17.35.030 Preliminary plat requirements.
A. Responsibility. The applicant shall be responsible for paying all improvement plan/report review fees at the time of plan/report submittal. The applicant shall be responsible for paying all costs for the installation of the improvements as a stipulation of zoning and/or preliminary plat which shall include at a minimum, but is not limited to, the following improvements:
1. Sanitary sewer system;
2. Water supply system;
3. Grading, drainage, and drainage structures;
4. Streets (public and private) and access ways;
5. Alleys (where applicable and approved);
6. Utilities (electric, telephone, cable television, gas, fiber optic/communications network, if applicable);
7. Traffic signals, street lights (where applicable and approved);
8. Monuments and signage;
9. Landscaping and streetscape;
10. Sidewalks, pedestrian and multi-use trails;
11. Street, pedestrian, trail lights.
It shall be the responsibility of the applicant to have an Arizona registered professional engineer, in the correct discipline, prepare a complete set of engineering plans and reports for construction of all required improvements and an Arizona registered landscape architect prepare a complete set of landscape plans.
B. Landscape Plans. A preliminary landscape plan, prepared a by registered landscape architect, shall be submitted as part of the preliminary plat application. Refer to the Design Standards Manual for information on specific submittal requirements.
C. Drainage Report. A preliminary drainage report shall be submitted as part of the preliminary plat application, and shall at a minimum contain information as required in the Design Standards Manual.
D. Traffic Impact Analysis. All traffic impact analysis shall be completed by a registered Arizona professional engineer with adequate experience in traffic/transportation engineering. A traffic impact analysis shall be submitted as part of the preliminary plat application and shall adhere to the guidelines in the Design Standards Manual.
E. Refer to Chapter 17.20 MCC, Platting Procedures and Requirements, for additional submittal requirements of the preliminary and final plat. All submittals shall be formatted in accordance with the Design Standards Manual. [Ord. 20-11 §2(14-7-3); Res. 20-31.]